Product ID:SUNPROOF NONCHALKING WHITE/PASTEL BASE, 1-1
MSDS Date:04/04/1991
FSC:8010
NIIN:00N025488
MSDS Number: BMBMX

Emergency Phone: 304-843-1300

Info Phone: 800-245-2590; 412-492-5555

Cage: 47695

Telephone: 1-800-245-2974 (CAL HYPO)

Cage: 47695

NO INGREDIENT FOR THIS FORMULATION_INGREDIENT

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:INGEST:HARMFUL/FATAL. EYE:CAUSES
EYE IRRIT. SKIN:MAY CAUSE MODERATE IRRIT. INHAL:VAP & SPRAY MAY BE
HARMFUL. VAP IRRIT EYES/NOSE THROAT. RPTD EXPOS TO HIGH VAP CONC
MAY CAUSE IRRIT OF RESP SYS & PERM BRAIN & NERVOUS SYS DMG.
INTENTIONAL MISUSE BE DELIBERATELY CONC & INHAL CONTENTS CAN BE
(EFTS OF OVEREXPOS)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:HARMFUL/FATAL. CHRONIC:AVOID LONG TERM
& RPTD CONTACT. PROD CONTAINS TITANIUM DIOXIDE. ANIMALS INHAL
MASSIVE AMTS OF TITANIUM DIOXIDE DUST IN A LONG-TERM STUDY DEV LUNG
TUMORS. POTENTIAL FOR INHAL OF TITANIUM DIOXIDE DUSTS FROM
COATINGS IS VERY LIM. SYMPTOMS: EYE WATERING, HDCH, DIZZ & LOSS OF
COORD (SUPDAT)

First Aid:INGEST:DO NOT INDUCE VOMIT. SEE MD. EYE:FLUSH IMMED W/PLENTY
OF WATER FOR AT LEAST 15 MIN. SEE MD IF IRRITATION PERSISTS.
SKIN:REMOVE PROMPTLY BY WIPING, FOLLOWED BY WATERLESS HAND CLEANER
& SOAP & W ATER. IF IRRIT PERSISTS, SEE MD. INHAL:REMOVE TO FRESH
AIR. APPLY ARTIF RESP & OTHER SUPPORTIVE MEASURES AS REQ. IF BRTHG
DIFFICULTY DEVELOPS, SEE MD.

Flash Point Method:PMCC
Flash Point:113F,45C
Lower Limits:1.0
Extinguishing Media:USE NFPA CLASS B EXTINGUISHERS (CO*2, DRY CHEMICAL
OR UNIVERSAL AQUEOUS FILM FORMING FOAM) DESIGNED TO EXTING (SUPDAT)
Fire Fighting Procedures:WATER SPRAY MAY BE INEFT. WATER SPRAY MAY BE
USED TO COOL CLSD CONTR TO PREVENT PRESS BUILD-UP & POSS
AUTOIGNIT/EXPLOS WHEN EXPOSED TO EXTREME HEAT. IF (SUPDAT)
Unusual Fire/Explosion Hazard:KEEP CONTR TIGHTLY CLSD. ISOLATE FROM
HEAT, ELECT EQUIP, SPARKS & OPEN FLAMES. CLSD CONTR MAY EXPLODE
WHEN EXPOSED TO EXTREME HEAT. DO NOT APPLY ON HOT (SUPDAT)

Spill Release Procedures:PROVIDE MAX VENT. ONLY PERSONNEL EQUIPPED
W/PROPER RESP & SKIN & EYE PROT SHOULD BE PERMITTED IN AREA. REMOVE
ALL SOURCES OF IGNITION. TAKE UP SPILLED MATL W/SAWDUST,
VERMICULITE/OTHER ABSORB MATL & P LACE INTO CONTR FOR DISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE ABOVE 120F. STORE LRG
AMTS IN BLDG DESIGNED & PROTECTED FOR STORAGE OF NFPA CLASS II
COMBUST LIQ.
Other Precautions:IF MATL IS PART OF MULTIPLE COMPONENT COATING SYSTEM,
READ MSDS FOR OTHER COMPONENT(S) BEFORE BLENDING AS RSLTG MIX MAY
HAVE HAZ OF ALL PARTS. AVOID FREE FALL OF LIQ IN EXCESS OF A FEW
INCHES. CONTR S HOULD BE GROUNDED WHEN POURING.

Respiratory Protection:VENT CONTROLS, VAP EXHAUST, FRESH AIR
ENTRY/NIOSH/MSHA APPRVD (TC-23C) PAINT SPRAY/AIR SUPPLIED (TC-19C)
RESP. READ RESP MFR'S INSTRUCT & LIT CAREFULLY TO DETERM TYPE OF
AIRBORNE CONTAM AGAINST WHICH RESP IS EFT & HOW IT IS TO BE PROP
FIT.
Ventilation:PROVIDE GENERAL DILUTION/LOC EXHAUST VENT IN VOL & PATTERN
TO KEEP CONC OF INGRED BELOW LOWEST SUGGESTED EXPOS (ING 9)
Protective Gloves:IMPERV SUCH AS NEOPRENE, NITRILE, LATEX.
Eye Protection:CHEM WORK GOGG/FULL LENGTH FCSHLD.
Other Protective Equipment:PROT CLTHG, INCLUDING IMPERVIOUS APRON OF
POLYVINYL ALCOHOL, NEOPRENE RUBBER OR NITRILE RUBBER.
Work Hygienic Practices:CLEAN OR DISCARD CONTAMINATED CLOTHING AND
SHOES.
Supplemental Safety and Health
EXT MEDIA:NFPA CLASS II COMBUST LIQ FIRES. FIRE FIGHT PROC:H*2O IS
USED, FOG NOZZ ARE PREF. WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT
EQUIP . EXPLOS HAZ:SURF. TOX GASES MAY FORM WHEN PROD IS CONTA CTED
BY FLAME/HOT SURF. EFTS OF OVEREXPOS:INDICATE SOLV LEV ARE TOO
HIGH. (ING 7)

Boiling Pt:B.P. Text:<280F,<138C
Vapor Pres:2.0
Vapor Density:HVR/AIR
Spec Gravity:1.26
Evaporation Rate & Reference:18 (BU AC = 100)
Solubility in Water:0.2%
Appearance and Odor:VISCOUS LIQUID WITH AN ODOR CHARACTERISTIC OF
SOLVENTS IN INGREDIENT SECTION.
Percent Volatiles by Volume:42.90

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS OR STRONG
OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:THERMAL DECOMP, WELDING,
BRAZING/FLAME-CUTTING SURFACES COATED W/PROD MAY PROD FUMES
INCLUDING CO.

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF IN ACCORDANCE
WITH FEDERAL, STATE, PROVINCIAL AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF
THROUGH AN APPROVED WAS TE MANAGEMENT FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.